03-25-2010 08:49 PM - edited 03-11-2019 10:26 AM
Hi All,
I have upgrade my ASA from 8.0.4 to 8.2.2 and post that ftp data traffic going over the VPN terminating on the ASA is not working, do i need to do any configuration change for this.
03-26-2010 04:55 AM
1) Was it working on version 8.0.4?
2) Do you have "inspect ftp" configured? and it's ftp running on default port?
3) I assume both end of the tunnel is ASA running version 8.2.2?
4) Can you share config from both end?
03-26-2010 09:43 AM
Hi
Thanks for your response, below are the answers to your queries do let me know if that leads to some solution
1) Was it working on version 8.0.4?
yes, it was working
2) Do you have "inspect ftp" configured? and it's ftp running on default port?
it is enabled, i tried disabling it also it didnt helped
3) I assume both end of the tunnel is ASA running version 8.2.2?
No one of the tunnel is PIX v 6.x and other ASA v 8.2.2, the ASA was upgraded also i have reverted it to old image for now so i can simulate issue any more.
4) Can you share config from both end?
I am sorry but i cnt share the configs, as per security constraints but if you have some suggestions or areas to look at in config that would be really greatfull.
Regards,
Guneet Singh Gulati
03-26-2010 01:37 PM
When it fails what do the logs show?
conf t
logging en
logging buffered debug
exit
sh logg | i x.x.x.x
where x.x.x.x is the ip address this being used to test ftp.
-KS
03-26-2010 03:13 PM
Also when does it fail? FTP Control fails? or FTP Data fails?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide