CORE-UBV-01#show module
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 48 48 port 10/100/1000 IEEE 802.3AT WS-X6148E-GE-45AT SAL1644RDQF
2 48 CEF720 48 port 1000mb SFP WS-X6748-SFP SAL1642QGQJ
3 6 Firewall Module WS-SVC-FWM-1 SAL1628GQJ9
5 2 Supervisor Engine 720 (Active) WS-SUP720-3B SAL1642QK0A
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
1 e4d3.f1cb.5070 to e4d3.f1cb.509f 1.3 8.4(1) 12.2(33)SXJ1 Ok
2 30f7.0d04.90a4 to 30f7.0d04.90d3 2.4 12.2(18r)S1 12.2(33)SXJ1 Ok
3 f0f7.5568.b788 to f0f7.5568.b78f 4.5 7.2(1) 20.1(2)SXJ PwrDown
5 ccef.4838.53c2 to ccef.4838.53c5 5.13 8.5(4) 12.2(33)SXJ1 Ok
Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ ----------- ------- -------
1 IEEE 802.3at PoE+ Daughter WS-F6K-48-AT SAL1644RFZ0 1.0 Ok
2 Centralized Forwarding Card WS-F6700-CFC SAL1642QGUW 4.1 Ok
5 Policy Feature Card 3 WS-F6K-PFC3B SAL1643QMLG 2.6 Ok
5 MSFC3 Daughterboard WS-SUP720 SAL1642QHXZ 5.1 Ok
Mod Online Diag Status
---- -------------------
1 Pass
2 Pass
3 Not Applicable
5 Pass
CORE-UBV-01#HW-module MOdule 3 RESET
Proceed with reload of module?[confirm]
% module 3 is operationally off (Module Failed SCP dnld)
CORE-UBV-01#
I have a problema with my integrated FW of my 6500.
I restarted the 6500 but nothings happens.
Any output would be greatly appreciated.