08-10-2011 04:01 AM - last edited on 03-25-2019 05:46 PM by ciscomoderator
In a terminal window on an FWSM module system context you get the number of access rules using the show resource acl-partition command.
This is really helpful and it would be nice to get this information on a daily basis to view in a chart. Is there a chance to get this information using SNMP? As far as I can see it's not in the Cisco Firewall-MIB.
Beat
Solved! Go to Solution.
08-13-2011 09:44 AM
Hi Beat,
You're right. The number of access rule count using the command "sh resource acl-partition" command is not available via SNMP.
Hope this is clear.
Regards,
Anu
P.S. Please mark this question as answered if it has been resolved. Do rate helpful posts.
08-13-2011 09:44 AM
Hi Beat,
You're right. The number of access rule count using the command "sh resource acl-partition" command is not available via SNMP.
Hope this is clear.
Regards,
Anu
P.S. Please mark this question as answered if it has been resolved. Do rate helpful posts.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide