Hello:
I have scenario where the customer wants to FWSM configured for intra-switch and inter-switch failover. Here is an example:
Core Switches - 6509-A and 6509-B
FWSM Modules in 6509-A -> FWSM-A-1 and FWSM-A-2
FWSM Modules in 6509-B -> FWSM-B-1 and FWSM-B-2
I am trying to achieve the following configurations:
1) configure FWSM-A-1 and FWSM-A-2 to be in active/standby mode, respectively, within 6509-A switch (Intra-switch failover)
2) configure FWSM-B-1 and FWSM-B-2 to be in Active/Standby mode, respectively, within 6509-B switch (Intra-switch failover)
3) Configure 6509-A and 6509-B to be Active/Standby mode, respectively, between the switches (Inter-switch failover)
Is it possible to achieve the above configuration? If it's can someone please direct me to a link or any support pages that might be helpful and any help/guide on this is greatly appreciated.
