general configuration on Firepower/ASA

[riderfaiz]

Hi everyone,

I just got this new device. I am new to this  Firepower5508  and have to complete the basic settings in a short period of time... I would like to ask:

1.) In the router mode, how do I change the security level for interfaces (like the old way for asa). In both gui and cli?

2.) In cli, I know the prompt is shown as ">". I like to ask..in general, how to change setting on the running configure?

3.) What about the NAT? If I like to do PAT (mapped all internal devices thru 1 wan ip), how do it do  it?

4.) As for the ACL, I do not want one inside 1 traffic to access to inside 2... but the other is true... What cli should I do?

I really find configuring the Firepower little difficult... especially my time is running out... hope you can help.

THank you for your help in advance.

[mikael.lahtela · Accepted solution]

First of all I'm guessing you are using Firepower Threat Defence, if not please tell us what software you are running.
If the questions are for FTD then:
1. There is no security levels in FTD.
2. You can't make changes from CLI in FTD.
3. You create a PAT rule in GUI as in old ASDM.
https://www.cisco.com/c/en/us/td/docs/security/firepower/621/configuration/guide/fpmc-config-guide-v621/nat_for_firepower_threat_defense.html#concept_90FAAF25405D40BF93F2D54D0234A0C5

br, Micke

[riderfaiz]

Hi Micke,

Thank you very much for your info. I hope I can find it easy to reconfigure it the way I want :)

Thank you very much again!

Takami Chiro