01-10-2020 04:39 AM - edited 02-21-2020 09:49 AM
When I login to ASDM, it loads the ASA Firepower module too
I manage SFR thru FMC and I don't want ASDM to check Firepower module while launching, is there an option to force ASDM to only load ASA config?
Solved! Go to Solution.
01-10-2020 04:57 AM
If the remote manager (FMC) is configured then the ASDM should only show Firepower module on the status tab, not in the configuration tabs.
01-10-2020 04:57 AM
If the remote manager (FMC) is configured then the ASDM should only show Firepower module on the status tab, not in the configuration tabs.
01-14-2020 08:00 AM
Thank you.
ASDM tried to connect to Firepower module at start up, is it default behaviour? I want to save my 3 seconds.
01-14-2020 12:30 PM
it is default behavior. as @Marvin Rhoads suggested if you have vFMC or Physical FMC in that case you can configure you sfr to connect to FMC and push polices from FMC to firepower sensor.
unless if you dont need sfr to do layer7 deep packet inspection than you can shut down the module. in that case you can save your 3 second of your life.
01-17-2020 02:57 AM
Thank you.
I was trying to find if there is a way to tell ASDM, 'well, I manage my sensor thru FMC, please know that you got nothing to do with it'.
But I'll leave with my 3 seconds delay:)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide