11-05-2014 01:22 PM - edited 03-11-2019 10:02 PM
We have 2 ASA 5525X V9.1.2 in active/passive failover mode; they are managed via their M0/0 interface
Is there a way to avoid that primary and secondary ASAs exchange their own IP addresses at time of failover ?
the objective is to allow each ASA to be always managed via the same IP address whatever their active/standby state ;
the "no monitor management" command only allows to avoid a failover to occur in case of failure of the management interface of the active ASA;
thank in advance for any help
11-06-2014 12:30 AM
Hi,
No , this will not be possible. This is because every component of the configuration will be replicated.
Thanks and Regards,
Vibhor Amrodia
11-06-2014 03:01 AM
ok, it's a pity ;
thanks for you answer
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide