How to clear most used count on PIX 515 (6.2)?

[laguado]

Hello,

How do I reset the most used counters for the sh xlate count and the sh conn count commands?

I tried "clear xlate count" but it has no affect.

Thanks.

[jsivulka]

The sh xlate count display the number of active translations. I don't think a command like "clear xlate count" exists. However, the clear xlate command exists and will clear the translations. Only when the translations are cleared will the count go down. For more information, please see http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_command_reference_chapter09186a0080104255.html#wp1063516

[ciscobuddy]

hi,

i hv pix 520 and 525, CRC errors are increasing on my DMZ interface. i want to clear the counters and monitor the DMZ interface. wht is the command to clear the counter.

if i clear the counter , is the connectivity is lost to pix interfaces.

pls help me ...very urgent

Thanks & Regards,

Ciscobuddy

[Patrick Iseli]

clear interface

Clear counters for the show interface command.

But you cannot define which interace. This will not reset any sessions just clear the counters.

Command reference:

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_command_reference_chapter09186a00801727a6.html#wp1091147

sincerely

Patrick