cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
396
Views
0
Helpful
6
Replies

How to configure active active Configuration

Vaibhav Narula
Beginner
Beginner

hI  , 

i am looking for a active active solution design   with the below desing  .

2 cisco asa  in  Site 1    in active /Standby  mode 

1  cisco asa  in Site 2 

Both the sites are connected on the private line  .

running all services from site 1 and  only  runnign specific service from site 2    , from site 2  how make  only some applications   hosted  on that site  ,

6 Replies 6

Julio Carvajal
Advisor
Advisor

Hello Vaibhav,

What do you mean by having 3 ASA's. There is no scenario that support's that.

You can only have 2 on a cluster ( running  active\standby or active\active)

Regards,

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC

keeping active  firewall  on the site2  with  switching and routing  on that level  . Donot want to break the  site1  firewall standby.

Hello,

The thing is that on a failover cluster there can only be 2 boxes and you are trying to make it happen with 3..

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC

my apologies i was not clear  i donot want to  run the cluster  from site 2  . Just use it  to redirect the  traffic from there  with switchin and routing for some small services

i was referning  from this post

https://supportforums.cisco.com/thread/222845

Hello,

Well, based on your other question, this cannot be possible as again you will need to have a way to determine wheter Site A is up or site B is up.

Routing protocols looks like the way to go

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers