10-22-2012 09:44 AM - edited 03-11-2019 05:12 PM
hI ,
i am looking for a active active solution design with the below desing .
2 cisco asa in Site 1 in active /Standby mode
1 cisco asa in Site 2
Both the sites are connected on the private line .
running all services from site 1 and only runnign specific service from site 2 , from site 2 how make only some applications hosted on that site ,
10-22-2012 10:26 AM
Hello Vaibhav,
What do you mean by having 3 ASA's. There is no scenario that support's that.
You can only have 2 on a cluster ( running active\standby or active\active)
Regards,
10-22-2012 10:30 AM
keeping active firewall on the site2 with switching and routing on that level . Donot want to break the site1 firewall standby.
10-22-2012 10:35 AM
Hello,
The thing is that on a failover cluster there can only be 2 boxes and you are trying to make it happen with 3..
10-22-2012 11:59 AM
my apologies i was not clear i donot want to run the cluster from site 2 . Just use it to redirect the traffic from there with switchin and routing for some small services
10-22-2012 12:02 PM
i was referning from this post
10-22-2012 01:02 PM
Hello,
Well, based on your other question, this cannot be possible as again you will need to have a way to determine wheter Site A is up or site B is up.
Routing protocols looks like the way to go
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: