how to configure AIM-IPS module on 4215?

[ksvy_ksvy]

my manager is installing a 4216 -w- 6.0 code. He is asking for whitepages on how to configure the 4-port module card. I'm not having any luck with locating "configuration" paper on this. Are there any instructions for this?

thanks, Kevin

[Sharkey13]

Kevin - here it is:

http://www.cisco.com/en/US/docs/security/ips/6.0/configuration/guide/cli/CLI6_0.pdf

Pls rate if helpful.

Patrick

[Farrukh Haroon]

Are you looking for hardware installation or software?

The AIP-IPS module goes into routers and not sensors as your topic post states.

Are you looking to install a 4FE card or an AIM-IPS into a router?

The Hardware installation guide is here:

http://www.cisco.com/en/US/docs/security/ips/7.0/installation/guide/hw_installing_aim.html

For the 4FE card, the software configuraiton is just like any other module, there is no special configuration for the interfaces (they are just like the built-in sensing interface).

Regards

Farrukh