Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. Last week we upgraded our ASA 5520 from 7.2.4 to 8.2.3. All is well with the upgrade, except today we find we have one L2L VPN that cannot send data to us (many others are working just fine). The tunnel actually builds OK, but no data can b...
Hello - I have what should be an easy configuration issue that I cannot figure out.Description: I have three routers (D, P, and V) that are connected to each other. All configured with EIGRP. Router P connects to core network.Problem: Router D lo...
Hello. This should be easy, but for some reason it is not....Background: trying to configure NTP on a core switch. Edge ASA has NTP configured on it and it is working.Issue: I cannot get core switch to synch NTP with either the ASA or the same NTP...
Good afternoon experts - I am in need of a quick resolution to what I am sure is a fairly standard configuration issue.Description: we need to configure a DMZ on an ASA for an FTP server with a public IP address. Outside partners need to send files...
Background: We are in the process of migrating to a new high speed internet connection. I have attached an ASA to the new connection as follows:ISP <==> Outside3750 <==> ASAI have been over this a hundred times, but I cannot figure out why I cannot...
Manish - I thought I would update you on this issue. What we found resolved this was to change the df-bit from copy to clear (crypto ipsec df-bit clear-df ), although copy was the default behavior both before and after the upgrade of the ASA from 7....
Peter- first of all, thank you for your very informative, concise response.Sh ip eigrp nei on router P showed the following:P#sh ip eigrp neiIP-EIGRP neighbors for process 2H Address Interface Hold Uptime SRTT RTO Q Seq ...
Collin - thanks for the reply. What I have since found out is that routers behind the switch can synch just fine with the NTP server, and the switch can synch just fine with any of those. But the switch still cannot synch directly with the NTP serve...
