04-20-2004 02:48 AM - edited 02-20-2020 11:21 PM
Hi!!! I have CiscoWorks 2000 Rwan with IPM. I installed and configure IPM to send snmp traps when the treshold is excedeed. I can see on the graph that it is exceeded but I can not verify that it sending snmp traps.Where to view these traps and how to configure snmp reciver host?
Can I use CW2k syslog analyzer automated action to generate mail when get this trap?
THANKS FOR ANY HELP!!!!
Regards
Enes
04-29-2004 12:17 PM
Hi,
As you've discovered, IPM can help configure
these traps:
http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/ipmcw2k/cipm25/ug/ipmfaq.htm#62205
But, you'll need to specify a dedicated NMS
server to receive these traps. The following
documentation should prove to be useful:
http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094aa5.shtml
http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094a05.shtml
You can use the appropriate "debug" command on
the router to confirm that traps are, in fact,
being sent.
The traps themselves are defined in the
CISCO-RTTMON-MIB.my and cannot interact
with the CW2000 syslog analyzer automated
action.
Thanks,
Roger
05-04-2004 02:06 AM
THANKS!!
How can I view these traps that IPM send to my CW2K on my CW2K.
Where are the traps!
I see with debug that they are sent to my NMS (CW2K)
Is there any chance to send tese traps as syslog messages?
THANKS FOR HELP!!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide