How to copy contents of ASA 5510 to another ASA 5510?

[puneitsupport]

Hello,

I want to copy contents of 1 ASA 5510 to another 5510.

Both ASA has same license.

-I tried to connect to 2nd ASA via console cable

-Went to "Conf t" and copied config of 1st ASA. [ using paste tab from Hyper Terminal ]

- used commands like copy running config disk0:/startup.config.cfg

- also used write memory all , wr mem commands

- But after reboot config was gone.

As of now I have ASA 8.3.x version in both ASA's.

How can I save config to 2nd ASA via Hyper Terminal?

[Collin Clark]

It would be easist if you used ASDM and did a full backup then restore it to the second ASA. That would copy everything including any certificates, custom profiles, AnyConnect clients, etc.

[puneitsupport]

I am trying to save basic config.

Basic config also not getting saved.

Steps followed as follows :-

- Given private IP to eth 0/1

- no shut

- speed auto

- wr

- exit

- wr

- exit

- hostname asasec

- wr

- reload

After reload firewall is not saving configuration.

[johnlloyd_13]

Hi,

Kindly post 'show version' output. Make sure the config register is 0x1.

Issue a 'no configuration-register' command if it's not.

Sent from Cisco Technical Support iPhone App