Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have 1 Cisco ASA 5510 with security Plus licenses & 1 Cisco Catalyst 3560 24-TS switch.I am done with vlan configuration in Cisco 3560 Catalyst switch.I have assigned eth 0/3 to vlan10 , eth 0/4 to vlan 20. eth 0/23 is trunk.I am able to pi...
Hello,I want to copy contents of 1 ASA 5510 to another 5510.Both ASA has same license.-I tried to connect to 2nd ASA via console cable-Went to "Conf t" and copied config of 1st ASA. [ using paste tab from Hyper Terminal ]- used commands like copy run...
Hello, Coming across requirement which is new to me as I have not done this setup. Details as follows. Hope some1 can help.Requirement: nat existing subnets to 192.168.50.0/24 subnet which is allowed at another firewall.Existing device: Cisco 5510 wh...
Hello,I am having Cisco 5510 ASA where I have created vlans.Using 3COM 4500 switch to terminate thsoe vlans.I want to replace 3COm switch with Cisco 3560 switch.I created vlans & trunk ports. [ using siwtch port access,trunk port command,no shut, enc...
Hello,I am not able to ping gateway's on my firewall from 1 subnet to another. What can be the issue ?Some details abotu existing network as follows :-ASA0 Config:- VLAN config done as vlan1, vlan2 on ASA , acl etc done, nating is done >> 3COM L3 ...
I tried that.Few issues I encountered as follows. [ inc I beleive some mistakes of mine ]1) I done with labelling eth interfaces on 3560, enabled port access mode, no shut etc [ names as per defined on ASA ]2) Done with creation of 2 trunk ports, en...
Hello Jon,Yes I want to replace 3COM switch with Cisco 3560 switch.Yes I have 2 ASA 5510's with Security plus bundle.But like I said if I do this major change & if my old Cisco 3560 switch goes off some day I have no dedundant/fail over L3 switch.Ex...
Thanks Jon & Steven for your valuable inputs.Now I udnerstood that I need to do some major changes in ASA before I put Cisco 3560 switch.Unfortunately I don't have redundant Cisco L3 switch as of now.1 additional doubt :- My existing 3COM 4500 swit...
I am trying to save basic config.Basic config also not getting saved.Steps followed as follows :-- Given private IP to eth 0/1- no shut- speed auto- wr- exit- wr- exit- hostname asasec- wr- reloadAfter reload firewall is not saving configuration.
