Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
729
Views
0
Helpful
1
Replies

How to monitor IPS sensor heath by emails?

MaksimGura
Level 1
Level 1

‎06-29-2010 10:27 AM - edited ‎03-10-2019 05:02 AM

Hi All,

Is there any way to configure e-mail notifications about IPS sensor health monitoring results?

I have tried to install IPS supported MIBs to my SNMP management station (actually, it is HP SIM). Cisco supported MIBs have not been installed successfully to HP SIM yet.

Also, I have been searching such a monitoring tool over cisco.com web site. And tools like LAN Monitoring Solution (or Device Fault Manager) requires licensing, so in my case it is not suitable.

Does somebody know SNMP management station (monitoring) tool which could monitor the sensor health without additional MIB installation?

There is one more practical question: Is there any way to send a test trap from IPS sensor to SNMP management station?

Thanks in advance,

Maksim

Labels:
0 Helpful
1 Reply 1

Christopher Dreier
Level 3
Level 3

‎07-06-2010 02:55 PM

Hello Maksim,

This functionality is not yet available, but will be included in IPS 7.1. This enhancement is being tracked via CSCsu08529.

Thank you,
Blayne Dreier
Cisco TAC IDS Team

**Please check out our Podcast**
TAC Security Show: http://www.cisco.com/go/tacsecuritypodcast

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card