cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

335
Views
0
Helpful
1
Replies
Highlighted
Beginner

how to nat a public address to dmz

2 questions on the asa

1. how do I nat a public address to a dmz address.

2. how do I oopen port 80/443 in the public to this address?

1 REPLY 1
Highlighted
Beginner

Re: how to nat a public address to dmz

This will depend on how many ip address you are using in the dmz . If for eg, you have have both a private and public ip configured on a server in the dmz zone that requires access from both inside and outside. then you would have to configure nat for outside to inside and no nat from inside to dmz.

pls elaborate on your setup

if you just want a nat command then

static ( dmz, ouside) public ip dmz ip netmask 255.255.255.0