How to Reboot FTD chassis || impact

[kamtarias]

Dear All,

I want to reboot FTD Chassis . I would like to know the command to perform the Operation and impact on FTD/Chassis/ Production.

Please help this is urgent!

[Rob Ingram]

@kamtarias login to SSH and run "reboot" and type y when prompted.

 > reboot
This command will reboot the system. Continue?
Please enter 'YES' or 'NO':

[kamtarias]

Hi Rob,

Thanks for reply. But I want only chassis to be rebooted . I hope you understand the requirement.

[kamtarias]

There is no option to reboot after ssh.

[Rob Ingram]

@kamtarias no, what hardware do you have?

[kamtarias]

Firepower 4115

[Rob Ingram]

https://www.cisco.com/c/en/us/td/docs/security/firepower/fxos/fxos201/cli-config/b_CLI_ConfigGuide_FXOS_201/system_administration.html#task_D35D9774FEB44A8F9FEFB1AB8AFBDB1F

Rebooting the Firepower 4100/9300 Chassis

Procedure

---

Step 1	Enter chassis mode: scope chassis 1
Step 2	Enter the following command to reboot the chassis: reboot [reason] [no-prompt] Note  If you use the [no-prompt] keyword, the chassis will reboot immediately after entering the command. If you do not use the [no-prompt] keyword, the system will not reboot until you enter the commit-buffer command. The system will gracefully shut down any logical devices configured on the system and then power down each security module/engine before finally powering down and then restarting the Firepower 4100/9300 chassis. This process takes approximately 15-20 minutes.
Step 3	To monitor the reboot process: scope chassis 1 show fsm status

[MHM Cisco World]

scope chassis 1 Example: firepower-2110 # scope chassis 1 firepower-2110 /chassis #
Step 2	Reboot the chassis. reboot

This suggestion please read about it before apply.

Thanks