cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
150
Views
0
Helpful
1
Replies

How to reconfigure ip-block on Firepower Management Chassis

I am in the process of setting up a new Firepower 9300. However, I accidentally misconfigured the IP block settings while trying to bring up the chassis manager, and now I cannot connect via HTTPS or SSH. How can I reconfigure the IP block to allow HTTPS access to the chassis manager?

 

Currently I am connected via Console/serial connection

 

This issue is resolved using the link: https://community.cisco.com/t5/network-security/can-t-access-fcm-after-re-imaging-and-initial-setup/td-p/4588406

1 Reply 1

nspasov
Cisco Employee
Cisco Employee

You have two options:

  1. Serial Console
  2. Directly attach a computer to the mgmt interface > Configure a static IP on the computer that is in the same subnet as the mgmt interface

Thank you for rating helpful posts!

Review Cisco Networking for a $25 gift card