cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
185
Views
0
Helpful
1
Replies

How to reconfigure ip-block on Firepower Management Chassis

I am in the process of setting up a new Firepower 9300. However, I accidentally misconfigured the IP block settings while trying to bring up the chassis manager, and now I cannot connect via HTTPS or SSH. How can I reconfigure the IP block to allow HTTPS access to the chassis manager?

 

Currently I am connected via Console/serial connection

 

This issue is resolved using the link: https://community.cisco.com/t5/network-security/can-t-access-fcm-after-re-imaging-and-initial-setup/td-p/4588406

1 Reply 1

nspasov
Cisco Employee
Cisco Employee

You have two options:

  1. Serial Console
  2. Directly attach a computer to the mgmt interface > Configure a static IP on the computer that is in the same subnet as the mgmt interface

Thank you for rating helpful posts!

Thank you for rating helpful posts!
Review Cisco Networking for a $25 gift card