01-25-2016 02:08 PM - edited 03-12-2019 12:11 AM
Not sure if this is the right place to ask.
Is it possible to add a static route of a network set in a Cisco ASA?
In our setup there are a number of networks and hosts of the RFC1918 network that we will need to route to a different interface then the outside interface.
We could add those networks/hosts one at a time in de static route options. This is time consuming. I was wondering if there is a solution, like adding a static route with a network set, so we can place al this networks in this set.
Solved! Go to Solution.
01-25-2016 02:55 PM
> Not sure if this is the right place to ask.
The Security -> Firewall forum would probably be better.
Sadly, there is nothing like that on the ASA (btw: which platforms have that?). You have to configure all your routes one at a time or use a routing-protocol with your neighbor to learn those routes.
01-25-2016 02:55 PM
> Not sure if this is the right place to ask.
The Security -> Firewall forum would probably be better.
Sadly, there is nothing like that on the ASA (btw: which platforms have that?). You have to configure all your routes one at a time or use a routing-protocol with your neighbor to learn those routes.
01-25-2016 03:03 PM
Unfortunately our neighbour wouldn't setup an relationship with us.
So it would be the only option for us to adding it manually one at a time.
Thnx for your reaction!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: