How to suppress or avoid increase of acl hit count in ASA

[RajaD]

Is there any specific command that i would need to make use of to suppress the hit count globally for all the acl statements in a cisco ASA 5525 Firewall ?? i am looking for global command if anything exists as such rather than "no log" at end of an acl statement to suppress log.

I just want the connection should be through with the configured ACL statement but i dont want the ACL statement to show up any increase in the hit count against that acl statement ?? Pls suggest.

I tried below, but nothing helped.

no logging permit-hostdown

no logging message 10000

Thanks in advance !!

[MHM Cisco World]

Hi 

If I am understanding you 

You want to make log appear few for same acl not appear each time traffic hit the acl ?

[RajaD]

yes i just dont want the acl hit count to increase at any time in the ASA acl statement though the connection is through, however if i look at the logs in the firewall by using "show logging" then the source to destination should still display the normal logging output.

[MHM Cisco World]

Config interval in acl and make it long