In CLI on ASA 5555-X I cannot figure out which command to use to see the "isakmp keepalive threshold" value set on a tunnel. I know the default is "threshold 10 retry 2" but I want to see if it has been changed on a specific tunnel and I seem to get everything else but this info. I have looked thoroughly through the Cisco CLI guide but I'm overlooking it or it's not there.
SMVASA1# show isakmp sa detail (closest I've come to getting info I'm looking for, but no keepalive value)
Here is sample output from another site but doesn't list any commands
tunnel-group 10.10.10.10 ipsec-attributes
ikev1 pre-shared-key *****
peer-id-validate req
no chain
no ikev1 trust-point
isakmp keepalive threshold 10 retry 2
no ikev2 remote-authentication
no ikev2 local-authentication
Thank you,
Alan
