05-24-2007 09:23 PM - edited 03-10-2019 03:37 AM
hi,
I will configure an idsm module (S/W version 6) in switch 6500 for the first time so , can i configure the module through IDM ( i.e graphical interface) like any sensor device or not??? and How can i do this??
best regards
Mohamed
05-24-2007 11:00 PM
The basic configuration has to be done via the CLI have a look at http://www.cisco.com/en/US/products/hw/vpndevc/ps4077/products_configuration_guide_chapter09186a0080459221.html
It should be similar for 5.X and 6.X.
Then you could login through your web interface to configure this as you do the appliance.
-Hoogen
Do rate if you find this post helpful :)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community