cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1403
Views
5
Helpful
7
Replies

Internet response times spike from average

mj11
Level 3
Level 3

Hi All

I was hoping that someone maybe able to help with an issue I am seeing, periodically we see the Internet response time is around 2000+ ms from an average of 20 ms. Looking at the logs this is all I see.

27Mar2012 08:43:26.645 44831.515 cidwebserver[438] IdsEventStore/W errWarning - the subscription lost data [IdsEventStore::readSubscription()]

27Mar2012 09:07:29.190 1442.545 sensorApp[531] IdsEventStore/W errWarning - the event store wrapped around [IdsEventStore::writeEvent(), index = 58591]

27Mar2012 10:42:49.922 5720.732 -cidcli[1733] Cid/W errWarning Session was closed by the remote end.

27Mar2012 14:01:28.808 11918.886 sensorApp[531] sensorApp/W DBMemoryResourcesCritical 1 Hits 1 Total.

Messages, like this one, in the category - DBMemoryResourcesCritical - were logged 1 times in the last 0 seconds.

27Mar2012 14:50:12.383 2923.575 interface[426] Cid/W errWarning Inline data bypass has started due to global correlation update.

27Mar2012 14:50:16.383 4.000 sensorApp[501] sensorApp/W Arena Excess growth of 2124964 detected at exit of CT getVirtualSensorStatistics.

27Mar2012 14:50:16.407 0.024 interface[426] Cid/W errWarning Inline data bypass has stopped.

27Mar2012 15:02:00.880 704.473 cidwebserver[433] tls/W errTransport WebSession::sessionTask TLS connection exception: handshake incomplete.

Messages, like this one, in the category - TLS connection failure - were logged 1 times in the last 867529 seconds.

27Mar2012 15:02:00.888 0.008 cidwebserver[12106] tls/W errWarning received fatal alert: certificate_unknown

Messages, like this one, in the category - receipt of TLS fatal alert message - were logged 1 times in the last 0 seconds.

27Mar2012 15:02:04.753 3.865 cidwebserver[432] tls/W errTransport while sending a TLS warning alert close_notify, the following error occurred: socket error [3,104]

Messages, like this one, in the category - TLS socket failure - were logged 1 times in the last 0 seconds.

27Mar2012 15:02:56.450 51.697 interface[426] Cid/W errWarning Inline data bypass has started due to global correlation update.

27Mar2012 15:02:56.883 0.433 interface[426] Cid/W errWarning Inline data bypass has stopped.

Does anyone have any ideas of the issue, the sensor verion 7.0(7)E4.

Regards MJ

7 Replies 7

sawgupta
Level 1
Level 1

Hi,

Though the messages look normal, sensor is using high amount of memory.

Is there a particular signature which is firing a lot ? Do you have latest signature set ?

Regards,

Sawan Gupta

Thanks & Regards, Sawan Gupta

Hi Sawan

Thanks for the update, do you know whats the best way to see if a particular signature is firing a lot.

Regards MJ

Yes.

Use the following CLI:

sh statistics virtual-sensor | be SigEvent count

You should get the output as following example:

Per-Signature SigEvent count since reset

             Sig XXXX.Y = n

             Sig ABCD.E = m

Regards,

Sawan Gupta

Thanks & Regards, Sawan Gupta

Hi

I have attached the outputs, if you are able to help this would be much appreciated.

Regards MJ

How much is the exact Memory Usage and Processing load on sensor ?

Use CLI "show statistics virtual-sensor"

Regards,

Sawan Gupta

Thanks & Regards, Sawan Gupta

Hi Sawan

Sorry have been delayed in my response.... Hopefully you will still have time to assist...

Regards MJ

The processing load and other stats look normal. You may want to open case with Cisco TAC.

Regards,

Sawan Gupta

Thanks & Regards, Sawan Gupta
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card