IPS Device Type: ASA5585-SSP-IPS10 and Enabled Signature

[sercopi]

Good evening

I have in produciton 2 Cisco IPS Device Type: ASA5585-SSP-IPS10 IPS Version 7.1.4(E4) with signature version 664.0

I have enabled on Sensor1 a few signatures and after I had to enable the same signatures on Sensor2, by flag individual check box also on Sensor2 (by Configuration -->Policies); is there a procedure (or task by IME 7.2.1 ) which can duplicate the signatures enabled on sensor1, also on Sensor2?

Thanks in advance

Best Regards

--

Giovanni Davide Saccà

[Julio Carvajal]

Hello,

You will need to perform that manually, there is no way you can do it dinamically as depending on each signature file you are using there are going to be some enabled and others not.

Regards,

Julio