Hi,
I have an ASA 5510 with IPS module enabled and i m trying to recover the login credentials, when trying the hw-module module 1 password-reset cmd returned an ERROR: % Invalid input detected at '^' marker. Please advice how can i recover the login and password
Thank you
# sh module 1 details
Getting details from the Service Module, please wait...
ASA 5500 Series Security Services Module-10
Model: ASA-SSM-10
Hardware version: 1.0
Serial Number: JAF14
Firmware version: 1.0(11)5
Software version: 7.0(2)E4
MAC Address Range: d0d0.fd52.b4ff to d0d0.fd52.b4ff
Data plane Status: Up
Status: Up
Mgmt IP addr: 192.168.1.2
Mgmt Network mask: 255.255.255.0
Mgmt Gateway: 192.168.1.1
Mgmt Access List: 192.168.1.155/32
Mgmt web ports: 443
Mgmt TLS enabled: true
sh ver
Cisco Adaptive Security Appliance Software Version 7.0(8)
Device Manager Version 5.0(8)
Compiled on Sat 31-May-08 23:48 by builders
System image file is "disk0:/asa708-k8.bin"
Config file at boot was "startup-config"
Hardware: ASA5510, 256 MB RAM, CPU Pentium 4 Celeron 1600 MHz
Internal ATA Compact Flash, 256MB
BIOS Flash M50FW080 @ 0xffe00000, 1024KB
Encryption hardware device : Cisco ASA-55x0 on-board accelerator (revision 0x0)
Boot microcode : CNlite-MC-Boot-Cisco-1.2
SSL/IKE microcode: CNlite-MC-IPSEC-Admin-3.03
IPSec microcode : CNlite-MC-IPSECm-MAIN-2.05
0: Ext: Ethernet0/0 : address is 0024.97f0.433e, irq 9
1: Ext: Ethernet0/1 : address is 0024.97f0.433f, irq 9
2: Ext: Ethernet0/2 : address is 0024.97f0.4340, irq 9
3: Ext: Ethernet0/3 : address is 0024.97f0.4341, irq 9
4: Ext: Management0/0 : address is 0024.97f0.4342, irq 11
5: Int: Internal-Data0/0 : address is 0000.0001.0002, irq 11
6: Int: Internal-Control0/0 : address is 0000.0001.0001, irq 5
Licensed features for this platform:
Maximum Physical Interfaces : Unlimited
Maximum VLANs : 25
Inside Hosts : Unlimited
Failover : Active/Standby
VPN-DES : Enabled
VPN-3DES-AES : Enabled
Security Contexts : 0
GTP/GPRS : Disabled
VPN Peers : 150
To reset the password, you must have ASA 7.2.2 or later.
