Is it possible to use distribute-list in eigrp on an FTD firewall?
I have an FTD 2110 Threat Defense device that I am configuring in Firepower manager. It needs to have eigrp running on it. I understand that eigrp needs to be configured via FlexConfig. I have built the FlexConfig policy and applied it, and everything seems to work except for one command. I need to filter incoming routes so I included a "distribute-list" command within eigrp but Firepower does not accept it. I used the same syntax as would be used on a standard ASA. Has the syntax changed? or is this not supported? If not supported, is there an equivalent config command that I can run? I have done multiple searches on this question and come up with nothing.
We have the Endpoint purge to delete any thing over 365 days, but this wasn't working as standard since in was installedSo disabled and enabled again and this seem to fix it, as had just under 200k endpoints captured. But it removed all clients that ...
When we unregister FTD from FMC and re-register, all the static routes are lost on it. Sometimes device has database corruption, if re-image is the only solution then upon re-image, FTD comes up fresh and we need to configure everything from scra...
Hi,I have a very simple question; we have two ASA 5585-X working in Active/Standby Mode with multiuser Contexts.Normally Primary Unit is active for failover group 1 and 2; Secondary Unit is standby !At the moment our Secondary Unit is completely disconnec...
Meet the Authors Event - CCIE Security and Practical Applications in Today’s Network: Zero Trust
(Live event – Thursday, 29th, 2020 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 6:00 p.m. Paris)
This event will have place on Thursday 29th, October 2020 at 1...
My company uses Microsoft Azure AD, and I sign into all my applications using that account. Can I use that account when I sign in?
Yes - all applications that support SecureX sign-on allow direct login with your Microsoft Azure AD accou...