ISA server in Cisco firewall DMZ zone

[sfanayei]

Hi all,

I have a ISA server that is behind firewall and it is connected to the Internet with static command:static (inside,outside) 192.x.x.x 10.x.x.x dns netmask 255.255.255.255 0 0 in my firewall.Is it possible to add the server to a firewalls DMZ at same time with the command:static (dmz,outside) 192.x.x.x 10.y.y.y netmask 255.255.255.255 0 0? I appreciate for any help.

[Jatin Katyal]

Hi,

There should be no issue by adding one more static-nat for DMZ server. But please make sure that we have two different public ip address's for both. If you have only one public ip than you have to configure port-redirection

PORT FORWARDING-REDIRECTING

---------------------------

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a00804708b4.shtml

HTH

JK

Plz rate helpful posts-

[sfanayei]

Dear HTH

I tank you for your respons. It seems to help a lot. I will consider it. Tanks again.

Bedst regards Sfanayei