ISE 1.1.1 login not working after install on VMWare on ESX 5.0

[dirks_2]

                   I did an ISE 1.1.1 installation on a VMWare with ESX 5.0. After installation I am not able to login with my credentials(username admin, password XXXX) I can ping my ISE server after initial installation but  I can not ping my ISE server after full installation.

I did the installation several times and even did it on a VM with differrent VMversion.

Anybody seen this before?

Thank You

Dirk

[komsakchim]

Hi dirks,

This is very simple and I can confirm to you that ISE 1.1.1 can run on VMware ESX 5.0 for sure.

I've it one in my lab.

[Naveen Kumar]

Hello Dirk,

I am giving you the installation guide for ISE on VMware and Esxi server. Please follow the steps, i have done my installation using this guide only.

http://www.cisco.com/en/US/docs/security/ise/1.0.4/install_guide/ise104_vmware.html

[Jatin Katyal]

Please clarify, are you able to ping the ISE or you're getting prompt for username and password but it's not accepting the credentials.

Jatin Katyal

- Do rate helpful posts -