Hi Team,
I am doing a POC for FTD with ASA 5515-x running latest FTD i.e. 6.1, I did the basic configurations with on-board manager/GUI. When I added FTD to FMC I was able to register it for a moment after that it showed error and then it unregister itself. I have below findings and questions:
1. Once I added FTD to FMC, I lost all the configurations (expect Mgmt. interface IP) which I did from on-board manager.
2. I deleted the ASA from FMC and cleared config-manager from FTD CLI however access to on-board manager is not working.
I am planning to reset the box and perform all configs from FMC however during initial setup itself we are seeing stability issues hence impacting Cu's sentiments on the product.
Any feedback on above issues seen would be helpful!!
