12-02-2015 10:37 PM - edited 03-11-2019 11:59 PM
Hi,
not sure this is the right forum but here goes.....
We have 40 sites on an MPLS network that are connected to 2 central sites. The 2 central sites are directly connected via a 100mb ethernet connection and are about 100 miles apart.
One of those sites is the ingress/egress point to our network and we use 2x 5520 in failover mode.
What we want to do is create another ingress/egress at the second site and load balance our internet connection. Can this be achieved and if so, briefly how and withe what ASA?
Thank you....
Solved! Go to Solution.
12-04-2015 03:22 AM
Hi Louis,
The PBR which is useful to create loadblancing of ISP is only availble after 9.4.1. But this version is not availble for the 5520 device. It is availble for X series of the firewall.
You can refer the below link which explains some of the ways to do the load blancing.
https://supportforums.cisco.com/document/49756/asapix-load-balancing-between-two-isp-options
Thanks,
Shivapramod M
Please remember to select a correct answer and rate helpful posts
12-04-2015 03:22 AM
Hi Louis,
The PBR which is useful to create loadblancing of ISP is only availble after 9.4.1. But this version is not availble for the 5520 device. It is availble for X series of the firewall.
You can refer the below link which explains some of the ways to do the load blancing.
https://supportforums.cisco.com/document/49756/asapix-load-balancing-between-two-isp-options
Thanks,
Shivapramod M
Please remember to select a correct answer and rate helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide