Loading 501 PIX PDM

[aftermath]

I feel funny about asking this question since I have ANSWERED some much more difficult. However, I am having an issue loading PDM from a tftp server onto the PIX...

I know that PDM is already on it, but I am having a problem getting it going..

Any suggestions..The config is attached..

Thank you.....

[jmia]

Tony,

You might have read the following document, but if not, have a read:

http://www.cisco.com/warp/public/110/upgrade.shtml

Hope it helps,

Jay

[aftermath]

I actaully have that, and used it's suggestions, so thank you.

I am actually getting the error listed below while trying to load PDM..It seems to be TIMIMG out, attempting to connect.

Thanks..

PIXNET# copy tftp flash

Address or name of remote host [0.0.0.0]? 192.168.1.1

Source file name [cdisk]? pix301.bin

copying tftp://192.168.1.1/pix301.bin to flash:image

[yes|no|again]? y

tftp: Timed out attempting to connect

Image not installed

[aftermath]

I am trying to load the PDM on a 501 PIX 6.3

But it keeps erroring out.." timed out attempting to connect "

Can someone look at the config above, and tell me if I have the commands in the proper order!

I can ping, and do a one hop trace to the inside PIX interface, but for some reason, it just will not hook up.

Any suggestions??