Network Security

Dear All, We had a problem when we implemented pix 535 over a WAN ( which is a bank network) .Hence its a bank network ,it includes ATM s also. while implementing this we faced problem with ATMs .Later on our CCIE has changed the timeout xlate to 119...

Bonjour,I have a pix configured with pppoe and he work fine.I have a local ftp server with address 191.0.128.100 and i want to access this ftp across internet.How can i configure the rule ?Sincerely

Any one with experience with CTR sending alerts to a SNMP Mgmt Center ? I have tried to send to Tivoli with not much luck in terms of formatted alerts (yes, mib loaded) as well as too much information (ie: not filtered to just critical alerts) being ...

Please How can detect a particular virus, by check up on a router ?Thank stephane

Hello all,I would like to know if I change timeouts on PIX firewall, do I just need "clear xlate" to bring them into effect or something else is required.TIA.AS

hi,I am trying to configure OSPF MD5 authentication between the private interface of VPN Concentrator 3005 and the internal router. The neigbor can not be established.While using the simple text authentication or no authentication, then OSPF works fi...

We are having an issue where some of our servers that have the CSA agent are getting kicked out of our domain since the remote call procedure is failing to negotiate with our domain controllers. The service comes back fine when you disable the host o...

GreetsWhat is the official Cisco position on applying Microsoft patches to Cisoworks servers running Windows 2000? Our server team wants to patch these servers regularly but we are concerned about the stability of the ciscoworks platform being patche...

Hi my cuestion is the following.Every how much, te hit count in the Cisco PIX access-list are reset to 0?. That is, this process every how much happen?

How can I change using my browser (PDM), the default inside's ip address (192.168.1.1) to (200.1.1.1)?I have tried several times, but as I lose the conection to the Pix 201, I can not execute the SAVE. After this I changed also my pc's ip address (20...

I'm trying to map 802.1p CoS to DSCP when policing the ingress of an L2TPv3 tunnel endpoint interface.2 commands exist in documentation.set-dscp-transmit or .However using 12.3(8)T4 on a 7206 doesn't give me the set-dscp-tunnel-transmit so i can't ap...

Hi All,I going to install 3 IDSs on my corporate network, can I configure these IDSs to alert administrator only when more than 2 of the IDSs dectect the same signature? If this can be done, how do I configure, any extra monitoring tool needed?regard...

Hi We are using Solaris box for EDI server, and on other edi end point is the Checkpoint NG box. Checkpoint doesn't have Solaris vpn client (only have windows version). Could use Cisco Soloaris client (we are using cisco vpn) to the Checkpoint box, o...

Hi guys,Two PIX 525 in failover topology. on every pix, the first iface is used for vlan logical interfaces (different security levels, etc) and the second ethernet is for failover/state link. everything works fine, and the problem is not related to ...