Logging Trap

[Tristan Apostol]

Hi Guys, 

Can i know if i use the Logging trap Debugging all the other severity are included? or can i use multiple severity?

Thank you.

Have a wonderful day ahead. 

[marce1000 · Accepted solution]

   - Yes , all severity levels will be included (and or not possible to specify  multiple severity levels)

 M.

[Marius Gunnerud · Accepted solution]

All severities are included when debugging is enabled.

[Tristan Apostol]

Thank you guys for the answer

[Marius Gunnerud]

Thanks you for the rating,  please remember to also select a correct answer as this helps contributors in achieving badges and other recognition within the support forum.  So please both rate and select correct answers

[balaji.bandi]

Logging trap Debugging all the other severity are included?

As others mentioned agreed with them and choosing the right option always is the best option. ( also make sure when you enable debugging message on console on high traffic will freeze the console access - that is the only draw back we see on console)

If you look at the below table 7 is debugging, so that covers everything what you need, but we debug logs are huge and we only run when there is an issue occationally, so choose the appropriate option required when you configuring syslog config.

0	Emergencies	System shutting down due to missing fan tray
1	Alerts	Temperature limit exceeded
2	Critical	Memory allocation failures
3	Errors	Interface Up/Down messages
4	Warnings	Configuration file written to server, via SNMP request
5	Notifications	Line protocol Up/Down
6	Information	Access-list violation logging
7	Debugging	Debug messages