cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
291
Views
0
Helpful
1
Replies

Looking for a way to export Firepower Management Center config to text

djhelms
Level 1
Level 1

We are looking for a way to export Firepower Management Center config to text so we can install to a "stand alone" ASA. We had a pair of FMC managed 5508-x ASA die on us and need a quick way to dump out the config in stored in FMC to clear text to install to temporary (-nonFMC) firewalls while the RMA is processing.  The export for FMC is not human readable. Is there a way to do this.  FMC v 6.3

1 Accepted Solution

Accepted Solutions

Marvin Rhoads
Hall of Fame
Hall of Fame

No it cannot be done. If the ASAs were running ASA image and Firepower service modules, FMC wouldn't know anything about the ASA config file in any case. The Firepower configuration in that use case would not transfer to any non-Firepower device.

View solution in original post

1 Reply 1

Marvin Rhoads
Hall of Fame
Hall of Fame

No it cannot be done. If the ASAs were running ASA image and Firepower service modules, FMC wouldn't know anything about the ASA config file in any case. The Firepower configuration in that use case would not transfer to any non-Firepower device.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card