キャンセル
次の結果を表示 
次の代わりに検索 
もしかして: 
cancel
396
閲覧回数
0
いいね!
1
返信

management in Failover mode.

kthned
Level 3
Level 3

Hi

 

I have a question on management of ASA confifigured with ASA failover. I dont understand why the management ips on both ASA need to be on the same subnet and why management configuration should be part of the configuration synchronization between the ASAs.

My question came up because we have both ASAs located in different location has Out-of-band management IP in different subnet  and we wanted to configure ASA failover feature.... The one solution is to extend the vlan to the second location but I dont understand why such implementation ?

 

Hope to learn the philosphy behind this :)

 

Regards,

Umair

1件の返信1

Marvin Rhoads
Hall of Fame
Hall of Fame

Failover ASA pairs are generally co-located as their inside and outside networks etc. are required to be the same. I suppose the thinking is if those are all present why not management too?

 

Review Cisco Networking for a $25 gift card