06-16-2014 06:40 AM - edited 03-11-2019 09:20 PM
Hi
I need to use switchport monitor command on my ASA 5515X 8.6(1) but I do not see that command under interface.
ASA(config-if)#interface gigabitEthernet 0/1
ASA(config-if)# s?
interface mode commands/options:
security-level shutdown speed split-horizon
summary-address
configure mode commands/options:
same-security-traffic service service-policy setup
sla smtp-server smtps snmp
snmp-map snmp-server ssh ssl
sunrpc-server sysopt
exec mode commands/options:
session show shun ssh
sw-module *s=show
Licensed features for this platform:
Maximum Physical Interfaces : Unlimited perpetual
Maximum VLANs : 100 perpetual
Inside Hosts : Unlimited perpetual
Failover : Active/Active perpetual
VPN-DES : Enabled perpetual
VPN-3DES-AES : Enabled perpetual
Security Contexts : 2 perpetual
GTP/GPRS : Disabled perpetual
AnyConnect Premium Peers : 2 perpetual
AnyConnect Essentials : Disabled perpetual
Other VPN Peers : 250 perpetual
Total VPN Peers : 250 perpetual
Shared License : Disabled perpetual
AnyConnect for Mobile : Disabled perpetual
AnyConnect for Cisco VPN Phone : Disabled perpetual
Advanced Endpoint Assessment : Disabled perpetual
UC Phone Proxy Sessions : 2 perpetual
Total UC Proxy Sessions : 2 perpetual
Botnet Traffic Filter : Disabled perpetual
Intercompany Media Engine : Disabled perpetual
IPS Module : Disabled perpetual
This platform has an ASA 5515 Security Plus license.
Could you advise why I do not see that command?
Solved! Go to Solution.
06-16-2014 07:51 AM
Hi,
This command is supported on models with built-in switch (like 5505) but not on higher end models.
From cisco Docs:
For models with a built-in switch, such as the ASA 5505 adaptive security appliance, use the switchport monitor command in interface configuration mode to enable SPAN, also known as switch port monitoring.
hth
MS
06-16-2014 07:51 AM
Hi,
This command is supported on models with built-in switch (like 5505) but not on higher end models.
From cisco Docs:
For models with a built-in switch, such as the ASA 5505 adaptive security appliance, use the switchport monitor command in interface configuration mode to enable SPAN, also known as switch port monitoring.
hth
MS
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide