Module Failed SCP dnld

[mj11]

Hi, I have a WS-SVC-IDSM-2 which is showing as PwrDown looking at the show power there is more than enough but there is an error message "Module Failed SCP dnld" does any body know why this is showing? it is something to do with the rom version.

Regards MJ

[a.kiprawih]

Sounds like IDSM2 rom issue, or switch IOS that does not recognise it. Sometime this is also happened to Firewall module (FWSM).

Do a 'show hw-module all fpd' and/or 'sh module'. Check the IDSM2 power status at the end of the line. Is the Status 'PwrDown'?

Check the IDSM-2 and switch version compatibility matrix. Issue 'sh version' on the switch, and check the IDSM-2 version (session into IDSM-2).

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/idsm/idsm_2/13074_04.htm#wp333372

HTH. Pls rate all useful post(s)

AK