Monitoring AnalysisEngine via SNMP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2013 07:46 AM - edited 03-10-2019 05:56 AM
Hello everybody,
I would like to ask if it is possible to monitor the analysisengine in IDSM-2 by SNMP. Time to time the engine stops working:
idsm# iplog-status
Error: getIpLogList : ct-sensorApp.651 not responding, please check system processes - The connect to the specified Io::ClientPipe failed.
I i would like to make the module send a SNMP if that happens.
I'm looking at his documet but I fail to see how to achieve above mentioned goal.
Thanks in advanco for any advice,
Best regards,
V.
- Labels:
-
IPS and IDS

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-23-2013 02:19 PM
We've been plauged by this problem for years. We set up a custom sig that fires every 5 min and if our external monitoring system doesn;t see a signature fire in 10 min, we alert the Ops folks.
- Bob
