Multiple hosts from dmz to outside

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-29-2015 03:16 AM - edited 03-11-2019 10:42 PM
Hello All,
Could i allow more than one server from a single DMZ port to access the internet via the outside port?
Thanks
- Labels:
-
NGFW Firewalls
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-29-2015 04:27 AM
For sure, just configure one dynamic NAT/PAT for your DMZ subnet or multiple NAT/PAT for each server in the DMZ.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-29-2015 08:38 AM
thanks Karsten...well in that case will both the servers be connected to the internet and accessed as well from the internet with two different public ips.
In my case I used static Nat however i was able to access both the servers from the internet but failed to access the Internet from the Server.
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-29-2015 10:22 AM
If you have static translations in place for your servers, there should only be access-control that limits the connectivity from the servers to the internet. Or it could be a failure in testing the connectivity (for example only with ping instead of "real" traffic).

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-29-2015 11:28 PM
its not only the ping however i couldn't update the server....
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-31-2015 08:43 AM
Which software version are you running? You may need to tune your NAT config.
