cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1100
Views
0
Helpful
13
Replies

multiple hosts in policy nat

RvanRouwendaal
Beginner
Beginner

how can i do this:

access-list AL200 permit ip host 172.16.11.27 Units 255.255.192.0
access-list AL200 permit ip host 172.16.11.27 Routers 255.255.255.248
access-list AL200 permit ip host 172.16.11.27 host IMSA
access-list AL200 permit ip host 172.16.11.27 host EIserver

access-list AL200 permit ip host 172.16.11.26 host GGSNnew
access-list AL200 permit ip host 172.16.11.26 Meterpool 255.255.240.0

static (production,outside) 172.16.11.200 access-list AL200 0 0

1 Accepted Solution

Accepted Solutions

You can policy PAT traffic from just two hosts to the given IP address (this will only work outbound), but you cannot do it with the configuration above. The policy PAT would look somewhat like this:

nat (production) 11 access-list AL200

global (outside) 11 172.16.11.200

Andrew

View solution in original post

13 Replies 13

RvanRouwendaal
Beginner
Beginner

Forgot to mention that i need to do this on a Cisco PIX 506e

So what i am trying to do is not possible?