10-02-2012 07:18 AM - edited 03-11-2019 05:02 PM
I need to configure nat from inside to dmz, i have already configured one network object and now need to apply static nat from inside tor dmz
It seems that you have to apply when the network object is being created but I am confused to how you amended Nat to the object after creation
The nat command i believe is nat (inside,dmz) static object_name
Any help would be greatly appreciated
10-02-2012 09:41 AM
Hello,
Actually there are 3 different ways to configure NAT on 8.3 or higher versions. Right now you are refering to the auto-nat but at least my opinion is to go with the Twice nat at this is the first taken into consideration by the ASA
Do the following
nat (inside,dmz) source static Real-IP_Object Mapped_Ip_Object
Any other question..Sure.. Just remember to rate all of my posts
Julio
10-02-2012 11:11 AM
Hello,
If you still want to use auto-nat, it is as follows:
******create the object*******
object network Real-IP
host 1.1.1.1
***** enter the object subcommand mode and add the nat rule********
object network Real-IP
nat (inside,dmz) static mapped-IP
After the static keyword, you can use an IP address, network object or the interface keyword.
Note: NAT for traffic between interfaces is no longer a requirement after version 8.3
Regards,
Felipe
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide