I have an ASA that is configured with the following...
Inside IP: 192.168.1.0/24
DMZ IP: 220.127.116.11/24
Outside IP: 18.104.22.168/30
*All IPs are fictious of course*
Currently my ASA is configured to NAT all inside IPs to the outside interface. My plan is to change the outside interface to a Private IP address, as I'm looking to put a router infront of it. Instead of NAT'ing to the outside interface, can I NAT to a free IP in my 22.214.171.124/24 block? If so, what would be the desired configuration?
global <?> 1 126.96.36.199.....?...not sure on the syntax. Looking for assistance on that as well
Are you responsible for risk management, compliance management and auditing of a network?
If so, we’d like to speak with you to learn your current processes of enforcing compliance and managing risk to help us develop services that will ...
Once you've expanded Cisco Secure Endpoint connector deployment to about 50% of your licensed count (check out this article that shows you how to do that), it's time to put those connectors to action i.e. convert them to Protect from Audit mode for vari...
Hello! I’m Betsy, UX Researcher, on the Cisco+ Secure Connect Now team. Nice to meet you all .We have a short survey to learn about your Zero Trust Network Access (ZTNA) journey. Whether you have, plan to, or have not implemented a ...
A set of interface access rules can cause the Cisco Adaptive Security Appliance to permit or deny a designated host to access another particular host with a specific network application (service). When there is only one client, one host and one se...
How To: Cisco ISE Captive Portals with Aruba Wireless
Authors: Adam Hollifield, Brad Johnson
IntroductionPrerequisitesMinimum RequirementsComponents UsedConfigurationAruba Wireless ControllerWLAN CreationAuthentication ConfigurationRole & Policy Confi...