Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Just wanted to start off by apologizing from the ugly diagram. Didn't really feel like busting other the other laptop for Visio. It may be ugly but I hope it does the trick in terms of information.Attached to this post I have a diagram th...
Hi All,Just wanted to start off by apologizing from the ugly diagram. Didn't really feel like busting other the other laptop for Visio. It may be ugly but I hope it does the trick in terms of information.Attached to this post I have a diagram that ...
Hi All,I'm looking at a design where I would have a few remote sites and a centralized WLC. My requirement would be to have a common SSID advertised across the remote sites and have that SSID locally switch; so to note tunnel all the traffic across ...
Hi All,Just a quick question...I have an ASA that is configured with the following...Inside IP: 192.168.1.0/24DMZ IP: 8.8.1.1/24Outside IP: 209.202.9.0/30*All IPs are fictious of course*Currently my ASA is configured to NAT all inside IPs to the outs...
Hi All,Just troubleshooting an issue here...I have two forests....with top level domains...DomainA1 and DomainB1... The Cisco ACS is installed on a server inside DomainA1..Users like JohnSmith.DomainA1 and JaneSmith.DomainB1 are able to authenticate ...
Alright...So if I configure the WLAN to support H-REAP Local Switching...is their anything further I need to do on the AP side?For instance...if the WLAN in question is called "Internal"...and I want this SSID to be common at the remote sites...will ...
Try manually shutting down the AIM-CUE using 'shutdown' then quickly 'no shutdown'. See if that helps. You'll have to go under the interface configuration mode of the Intergrated-Services module.
