- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-20-2022 10:13 AM
Hello
I am trying to NAT Host 1 192.168.1.1 to WAN-1 (195.145.1.1) and NAT the Host 2 192.168.2.1 to WAN-2 (186.145.1.1), but when i try to config the PAT NAT for host 2 the nat only works when the WAN-1 interface are disabled .
any ideas how to fix this ?
Cisco ASA 5505x NATIN
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-20-2022 10:52 AM
because the ASA not support load-sharing with dual ISP,
you need PBR and then add your NAT.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-20-2022 10:52 AM
because the ASA not support load-sharing with dual ISP,
you need PBR and then add your NAT.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-20-2022 12:58 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-20-2022 01:14 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-20-2022 02:13 PM
Thanks! it Worked right a way
