Native VLAN on ASA5506

[Kristian Leth]

Hello,

Im in the progress of upgrading my ASA 5505 to an 5506, and i cant seem to figure out, where to enable the native VLAN...

Today im using VLAN 1,2,3 and 4, and using VLAN 100 as native VLAN for trunking.

If configured the subinterfaces on the ASA5506, but im afraid i might get a vlan mismatch, since i cant seem to find the native VLAN setting.

Does someone know, where to set this ?

[Jon Marshall]

Kristian

I am moving this thread to Firewalling but as far as I know the answer to your question is that with the 5505 you could actually configure ports as trunks because they were L2 ports so the native vlan setting was relevant.

However with the 5506 the ports are L3 only so you can't configure as a trunk so the native vlan does not really come into assuming you are not using the native vlan for data.

Jon