- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-21-2009 11:21 AM - edited 03-11-2019 09:29 AM
Hello,
On an ASA5510 v8.0(4) is there a way to create a network object group and enter a range of addresses rather than entering them one at a time? For instance I have a group that will need IP address 192.168.1.60 to 192.168.1.75. Do I have to enter them one at a time?
Thank you in advance.
Andrea
Solved! Go to Solution.
- Labels:
-
NGFW Firewalls
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-21-2009 11:26 AM
Andrea
You cannot enter as a range but with the IP range you give above you could enter a subnet/mask pair ie.
network-object 192.168.1.60 255.255.255.240
Jon
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-21-2009 11:26 AM
Andrea
You cannot enter as a range but with the IP range you give above you could enter a subnet/mask pair ie.
network-object 192.168.1.60 255.255.255.240
Jon
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-21-2009 11:36 AM
Jon,
Thank you very much!
Andrea
