Hi guys,
today one of our Sourcefire sensors (3D8130) is giving us a hard time. The error in Defense Center is Module Inline Link Mismatch. That led me to believe that probably the auto-negotiation is not working anymore. When i went in to disable the propagate link state ( to see on which side the error is happening) , i encounter the following error :
"Remote Task Failure : Detection reconfiguration failed: Could not connect to NMSB device: no handles available Error reconfiguring Netronome hardware! Change reconciliation failed! Failed to apply detection configuration: Invalid Argument"
If i check the logs, i found interesting the following logs
"FailD:HAState [WARN] NMSB Failure - admin down now
SF-IMS[22369]: [22369] bb-health:bb-health [ERROR] Error initializing interface list! (1) "
if i try to setup a capture from CLI, it doesn't work. Same thing if i do a show traffic traffic statistics..It just get's me back to the prompt
> show traffic-statistics
=================[ Traffic Status ]=================
--------------[ Physical Interfaces ]---------------
>
It fails even when i try to do an Intrusion Policy update.
I tried to do some research over the internet for this issue, but i was not able to find anything that could help.
Any help from your side is greatly appreciated.
