11-25-2018 09:52 AM - edited 02-21-2020 08:30 AM
Hi,
Did anyone online adjust clustering health-check holdtime on Firepower4100 running ASA application?
Will that impact the cluster operation?
I don't find a reference document.
11-25-2018 11:55 AM
here is the default settings :
The cluster health check feature is enabled by default with the holdtime of 3 seconds. Interface health monitoring is enabled on all interfaces by default.
Connection rebalancing is disabled by default. If you enable connection rebalancing, the default time between load information exchanges is 5 seconds.
The cluster auto-rejoin feature for a failed cluster control link is set to unlimited attempts every 5 minutes.
The cluster auto-rejoin feature for a failed data interface is set to 3 attempts every 5 minutes, with the increasing interval set to 2.
Connection replication delay of 5 seconds is enabled by default for HTTP traffic.
here is the document for your reference :
11-26-2018 06:15 AM
Hi Balaji,
Thanks for your reply!
But I want to know is:
Will anything happen after issue "health-check holdtime 10" to adjust default time?
11-26-2018 09:06 AM
Not that i am aware which will have effect, But good to do all the changes in maintenance and change window.
Let me know how it goes ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide